Введение
In this guide it will take you through the process of replacing the motherboard. Please make sure the screws from the prerequisite guides are removed.
Выберете то, что вам нужно
-
-
With all the screws removed from the previous guides. Remove the final eight M2.5X5 mm Philips screws on the back of the laptop
-
-
-
In the battery housing, there are three screws that hold the keyboard on. These screws are located on the side near the front.
-
In the center of the bottom of the computer between the RAM and the wifi antenna is a 4th keyboard screw that also needs to be removed.
-
-
-
Open up the front of the laptop. Use a plastic opening tool to carefully pry open the keyboard from the edges.
-
-
-
-
Locate the keyboard cable/wire that attaches the keyboard to the laptop .
-
Locate the latch of the wire connector
-
Unlatch the wire connector and gently pull out the wire with your hands
-
-
-
Remove the four M2.5x5 mm Phillips screws from the exposed keyboard cover.
-
-
-
Locate the three tab holding down the cover of the Motherboard.
-
Lift the tabs with using either a plastic opening tool or your fingers.
-
-
-
Locate the four cables securing the Motherboard.
-
Gently pull cables to unsecure them.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
3 человек успешно провели ремонт по этому руководству.
Команда
USF Tampa, Team 2-6, Sullivan Fall 2016 Участник USF Tampa, Team 2-6, Sullivan Fall 2016
USFT-SULLIVAN-F16S2G6
3 членов
Автор 12 руководств
